黑洞社区

Two years ago, the government pledged to toughen up the regulations relating to the conservation of fuel and power by 2005. It will fail to do this. Even though the start date for the revised version of Part L of the 黑洞社区 Regulations, 1 January 2006, misses this pledge by just one day, in reality Part L is unlikely to be enforced until April next year. The approved documents are not set to be published until this autumn and the industry is usually given six months between this date and enforcement.

The reason that the government has given the start date as 1 January is all to do with the European Union鈥檚 Energy Performance of 黑洞社区s Directive (see page 17). This directive requires EU member states to have a methodology in place by 4 January 2006 for calculating the energy performance of buildings. This must be based on every element that might affect it, whether it be fabric heat loss, daylight calculations, internal lighting efficiency, airtightness of the envelope, or heating and ventilation system type and efficiency.

The energy calculation procedures of Part L, which are contained in the documents SAP 2005 for dwellings and SBEM for non-domestic buildings (see page 15), are the means by which the UK government intends to meet this requirement. SAP is the government鈥檚 recommended system for the energy rating of dwellings, and the Simplified 黑洞社区 Energy Method is the method used to work out the energy performance of non-dwellings. The underlying object of these procedures is to reduce the overall energy consumption as measured by the total annual CO2 emissions (kg/m2 of gross floor area). For non-domestic buildings, the proposal is to reduce the energy consumption by 20% for air-conditioned and mechanically ventilated buildings and 15% for naturally ventilated buildings. There is also a proposal for non-domestic buildings to contribute 10% of their energy from renewable sources. In most non-domestic buildings the energy used needs to be 28% lower than the requirements of the 2002 edition of the 黑洞社区 Regulations. If the 28% reduction is not met, building elements, systems or airtightness will need to be changed. Targets laid out for new non-domestic buildings also include a maximum U-value target of 0.35 W/m2K for walls and 0.25 W/m2K for roofs (see 鈥淧art L targets鈥�).

Achieving the requirement of providing 10% of energy from renewable sources will be challenging, particularly if a reasonable payback is required. Designers will need to address and cost options such as solar heating (evacuated tube) systems, solar photovoltaic cells, heat pumps, combined heat and power systems, wind generators, light pipes, phase change storage, and so on.

It will require a much more multidisciplinary approach to design than currently exists

The energy performance of the proposed building needs to be demonstrated before construction. Then, before the building is handed over, all of the parameters as installed and tested need to be input to the National Calculation Methodology. The building must attain the required carbon emission target, according to this method, before 黑洞社区 Control will be satisfied.

All of the above will require a different culture within the industry, as there will need to be an integration of the building services elements with the architect鈥檚 basic building design. 黑洞社区s should be designed, for example, on the basis that 28掳C is not exceeded (in office spaces) for more than 20 hours a year. This requires a much more multidisciplinary approach to building design than currently exists.

The government is serious about climate change and our need to save energy. Mandatory building log books and energy metering will increase energy efficiency in building. There will also be another revision of the 黑洞社区 Regulations in five years鈥� time, as well as second tier documentation, which can be altered at any time without changing the regulations themselves. Everyone in construction will have to take note.